Health

How to Unclog a Toilet

If your toilet is clogged, don’t flush it repeatedly. The toilet bowl can’t hold much more than a tank full, so it’s likely to overflow it you flush it more than once. Rather, try unclogging the toilet by plunging, lubricating or snaking. If the toilet is clogged from too much toilet paper, simply letting the full bowl sit for a few hours will sometimes do the trick. The paper will break down on its own and then you can flush it away .

If the clog source is bigger or more serious, the first thing you should try is plunging the toilet with a funnel-cup plunger.

Cover the drain with the plunger.

Quickly pull the plunger off the drain opening. Repeat this several times, until the clog is pulled out.

Be careful to plunge in a way that will pull out the clog rather than pushing it deeper down.

If the water is draining too slowly, you can try lubricating the drain.

Mix a gallon (3.8 liters) of hot (not boiling) water with a few tablespoons of lubricant, such as dish soap or cooking oil.

Pour mixture into the toilet.

Let it sit for a few hours.

Try flushing

If you need to “snake” out the toilet, use a closet auger; not a snake. A snake will scratch up your toilet bowl’s porcelain, while an auger has a soft, flexible sleeve that will prevent scratching

Feed the tip of the auger gently into the opening.

Crank clockwise while pushing down, until you feel resistance.

If the auger gets stuck, crank it counter-clockwise while pulling back. Once it’s freed, you can resume cranking clockwise until the auger is as far down as it can go. Its sleeve should be at the bottom of the bowl.

Continue cranking as you pull the handle up.

If the auger jams, push gently and then pull again.

Remove the auger when the blockage is cleared.

Use the plunger on the drain just in case there’s still some leftover debris.

Flush to check that the water is draining freely.

If you find yourself without a plunger, check out these two methods for getting it unclogged.

How to unclog your toilet without a plunger

Plunger

We’ve all been there. The toilet is clogged and you can’t find your trusty (and probably crusty) plunger. No sweat! As long as you don’t make this mistake which will make your clogged toilet so much worse, we can get you through this! These hacks will help you unclog a toilet without a plunger, whether you lost it, refuse to touch it, or are looking to live a plunger free life.

Start with dish soap

Soap

As soon as the toilet clogs, head to the kitchen and fetch some dish soap; the slippery soap should help lubricate the clogged pipe and allow the lodged debris to slide down more easily. Pour about a half-cup into the toilet. If you haven’t got any dish soap on hand, chop bar soap into small chunks and drop the pieces into the toilet. These are the 12 things you should never flush down the toilet.

Add hot water

Add hot water

If dish soap alone doesn’t do the trick, adding water might move things along. Fill a bucket with hot bath water (boiling water could cause a porcelain toilet to crack), and pour the water into the toilet from waist level. The force of the water could dislodge whatever is causing the clog.

DIY a drain snake using a wire hanger

Wire Hanger

Disclaimer: right before you googled “how to unclog a toilet without a plunger,” you probably should have determined what is causing this blockage. A more severe blockage could require manually moving the item. To do this, unravel a wire coat hanger until it’s straight. Push one end of the wire into the clogged area. Prod the debris until it becomes free and flows down the drain.

Try this mixture

Mix alternative

As an alternative to using dish soap, try this all-natural solution: Pour 1 cup baking soda and 2 cups vinegar into the toilet. Allow it to fizz for a half hour. If the clog doesn’t dissipate, try the hot water trick to unclog a toilet without a plunger. And try not to be too grossed out—here are 9 everyday items dirtier than a toilet seat.

When to Call the Plumber


There are times when your own efforts just aren’t enough. How do you know when it’s time to call in the professionals to battle your clog? If you see water backing up in the sinks or showers whenever you flush, it’s time to bring in a plumber. Water backing up in odd locations when you flush means you have a clogged main line. A plunger and auger won’t get the job done.

How to Avoid Clogged Toilets
First, teach children that the toilet is not a Jacuzzi or water ride for their GI Joes.

It’s important to ensure the jets around the toilet bowl’s edge are nice and clean. Stopped up jets will prevent the toilet from flushing at full power which in turn prevents you from clearing out the toilet and its contents. Weekly toilet cleaning with a brush will prevent build-up. If you haven’t cleaned the toilet in a while, you’ll probably have mega buildup. Using an Allen wrench or screwdriver to clear out the junk.

Finally, take it easy on the paper. You don’t need an entire roll to wipe your bum.

How to Unclog a Toilet with Baking Soda

Troublesome toilet clogs are frustrating to deal with, especially when you need use of the toilet in your home! Luckily, you will be able to fix many toilet clogs cheaply with the help of baking soda and a plunger, before you resort to calling a plumber. It’s also important to follow some basic guidelines to prevent future clogs after you get your clogged toilet running smoothly again.

STEP 1
Using Baking Soda and Vinegar


Pour 1 cup (240 mL) of baking soda into the clogged toilet. Measure out the baking soda with a measuring cup or scoop and dump it into the toilet bowl. Let it sink to the bottom of the sitting water and settle.[1]
Baking soda has lots of household cleaning uses, so it’s a good item to keep on hand from your local supermarket!

STEP 2


Add 1 gallon (3.8 L) of boiling water and see if the toilet unclogs. Boil the water in a kettle and carefully pour it into the toilet bowl. Don’t do this if the water level is already high in the toilet bowl.[2]
The heat and pressure of the water can help unclog the toilet faster. If you hear a suction sound and see the water draining out, then gravity and the hot water were enough to unclog the toilet. Give it a flush to see if it works as it should.[3]

STEP 3

Pour 2 cups (470 mL) of white vinegar into the toilet if it is still clogged. Pour very carefully, and pay close attention to the reaction between the vinegar and baking soda so that it doesn’t fizz over the toilet bowl. Stop pouring and wait for the fizzing to subside if it gets too high, then continue pouring until all the vinegar is in the toilet bowl.[4]
The “volcanic” reaction between the baking soda and vinegar is what unclogs the toilet, but be very careful not to let it erupt all over your bathroom floor!


STEP 4


Let the mixture sit for at least 2 hours, or overnight until the water drains. Check on the toilet after 2 hours have passed, and try flushing it if the sitting water has drained. If it looks like it is still clogged, let the mixture sit overnight before you flush it.[5]
Repeat this process if the toilet does not unclog the first time.

All Natural DIY Recipe – Safe and Effective Toilet Declogger

It worked! This all-natural DIY recipe really worked.  Not just once, but it did the trick two different times on my completely clogged toilet. (Yes, we have really crappy toilets–no pun intended.)

Let me tell you, I was one happy homeowner upon discovering this simple, cheap, and safe DIY solution!  That’s because a plumber visit costs at least $150 and Drano and Liquid Plumbr scare the snot out of me.  Seriously, listen to the warnings from the Liquid Plumbr company itself about the dangers of its product:

“…Never use Liquid-Plumr with other drain-cleaning products. The bleach contained in Liquid-Plumr can react with other chemicals, such as ammonia, to create toxic vapors. Also, use of a plunger can be dangerous, as the product can damage skin, eyes and mucus membranes on contact…Handling lye in any form can cause chemical burns and skin damage and ingesting it can result in permanent injury or death.

Do I want a chemical compound like that in my house, near my babies, in our water system?  No spanks.

The best part, besides the fact that this all-natural DIY actually works, is that it only requires two CHEAP ingredients out of my kitchen cabinets. Check out this DIY recipe my 3-year-old could make and administer to said clogged toilet…

All-Natural DIY Recipe

1) Into a clogged toilet filled with standing water, dump 1 cup of baking soda.  Let it sink to the bottom.

2) If the toilet doesn’t have much water, add 1 gallon of boiling water to really get things moving.

3) Next, add cups of vinegar slowly, so it won’t fizz over onto your floor.  Ickkk!

4) Let it sit for a couple of hours and see if the water has drained.  If it has not, let it sit overnight and then plunge, if needed, before flushing.

My Test Results of the DIY

Tonight, I tossed in the DIY and let it sit for a couple of hours.  When I returned, the standing water was gone and the toilet flushed right away!  However, the first time I used this all-natural DIY recipe, I had to let the concoction sit overnight in the toilet.  After a good plunging, it began to work a little better.  I used the DIY one more time, and after a few hours, the toilet was completely unclogged.

From my research, it sounds like this is safe and effective to use in kitchen and bathroom sinks and drains, as well.  One tip I read was to hold something over the opening of the drain so the fizz goes down it instead of back up and out.  Obviously, I didn’t do this for my toilet!

May the toilet unclogging force be with you next time you give this DIY a try!









Leave a Comment

Do NOT follow this link or you will be banned from the site!